Mac mini hard drive replacement ssd




Finding Your Mac’s Model

Lift the hard drive from the edge nearest the logic board and remove it from the mini, minding the RAM socket and any cables that may get caught.

What Macs Hard Drives Can You Upgrade?

When reinstalling the hard drive, be sure the two T8 Torx lugs on its far end are inserted into the two rubber grommets highlighted in red in the second picture before sliding the logic board back into place. Remove the hard drive cable by pulling its connector straight away from the hard drive.

Remove the piece of tape covering the thermal sensor attached to the edge of the hard drive. Press the spacer onto the SSD as shown; proper orientation will ensure the spacer does not cover any screws or screw holes. I did not complete this guide. Dozuki System and 5 other contributors. Difficulty Moderate.

OWC Solid State Drives

Steps Time Required Sections 6. Flags 0. Introduction Use this guide to completely replace your mini's hard drive. Step 1 Bottom Cover.

Upgrading New 2014/ 2015 Mac Mini to SSD (Solid State Drive)

Add a comment. Add Comment. Step 2. Step 3 Fan. They have guides for every Mac model and sell all the parts you need. The one caveat to that is if your Mac is old enough to use standard 2. Head to iFixit and find your Mac model.


  • Mac mini Late 2014 Hard Drive Replacement.
  • brick breaker free download for mac;
  • Mac Mini Mid 2010 SSD Installation.
  • Upgradeable.

You can see the guide to replacing the SSD is right there. That way you can easily migrate all your old files. The Best Tech Newsletter Anywhere. Buy these tools. Buy these parts. Do not completely remove the antenna plate; it is still connected to the Mac mini by an antenna cable.

Introduction

Use the point of a spudger to lift the antenna connector straight up off its socket on the airport card. Carefully pull the antenna cable out from the gap between the power supply and case. The fan connector is trapped under the edge of the fan and cannot be disconnected until the fan is moved. Lift the fan straight up to free the captive screw from its hole in the logic board.

Use the point of a spudger to lift the fan connector straight up out of its socket on the logic board. Use the flat end of a spudger to lift the SATA cable connector up off of its socket on the logic board. Use the tip of a spudger to disconnect the IR sensor cable connector by prying it straight up from its socket.

Skip the next three steps if your Mac mini only has a hard drive.


  1. How to use a SSD to speed up your Mac Mini.
  2. murder she wrote game download for mac!
  3. Can the HDD be upgraded to a SSD?!
  4. digital comic book reader for mac.
  5. uninstall windows xp from mac parallels.
  6. How to Upgrade Aluminum Mac mini Hard Drives or SSDs: qyweqybi.tk!
  7. Can You Upgrade the Hard Drive or SSD In Your Mac?.
  8. To remove the logic board, the two cylindrical rods of the Mac mini Logic Board Removal Tool must be inserted into the holes highlighted in red. Inserting instruments into any logic board holes other than the ones highlighted in red may destroy the logic board. Be sure the rods make contact with the case under the logic board before proceeding. Cease prying when the removal tool makes contact with the opening in the rear case.

    Carefully slide the logic board assembly out of the Mac mini, minding any cables that may get caught.

    SOLVED: Can the HDD be upgraded to a SSD? - Mac Mini Late - iFixit

    Use tweezers or your fingers to pull the clip away from the AC-in socket, and remove it from the Mac mini. When replacing the clip, push it in until it stops—it should be secure even if there is no audible click. To free the power supply from the case, grab the AC-In connector, which acts like a latch. During reassembly ensure the power supply is inserted far enough into the case that the latch will engage with the groove.

    Installing an SSD in Mac Mini?

    Remove the four two on each side 6. During reassembly, be sure to thread the hard drive cable through the slot in the drive tray. Lift up the ribbon cable and carefully peel away the black tape underneath. Failing to remove the tape will almost surely cause the contacts soldered to the flex cable to rip from the connector housing, as the retention force of the contacts in the housing is quite low.

    Carefully peel off the two black, square-shaped sticky pads one visible in picture from the corners of the hard drive, and stick them to your new hard drive in the same locations.


    • ?
    • Mac Mini Mid SSD Installation - Crucial?
    • Add your answer.
    • Why is the MX500 the only SSD listed?!
    • how to convert picture clipping to jpeg on mac.
    • windows 8 change mac address registry.
    • Choose your SSD size.
    mac mini hard drive replacement ssd Mac mini hard drive replacement ssd
    mac mini hard drive replacement ssd Mac mini hard drive replacement ssd
    mac mini hard drive replacement ssd Mac mini hard drive replacement ssd
    mac mini hard drive replacement ssd Mac mini hard drive replacement ssd
    mac mini hard drive replacement ssd Mac mini hard drive replacement ssd

Related mac mini hard drive replacement ssd



Copyright 2019 - All Right Reserved